5/7/2023 0 Comments Red alarm meanIn the Gloucester, Va area you can contact our expert team for assistance. However, if the red light is still on, contact your septic company for emergency service. If the red light goes out, that means the system is working properly and just needed to catch up with the excess water overflow in the tank. Try to minimize water usage during this time. Let the septic system run a couple of pump cycles (should last about 10-15 hours) and the red light on the alarm box may go out on its own. If the breaker happens to be on, check to see if there is any standing water surrounding the septic tanks. Next, check the septic breaker to ensure the system has power. The red light indicates the alarm is receiving a signal from the pump tank that the water level is rising higher or is dropping lower than it should be. The green light means that the alarm has power and should always be on. There should be a red light and a green light located somewhere on the alarm box. If the alarm happens to be going off, the best thing to do is to push the red button or switch on the alarm box. Anything, including the pump, floats, alarm, and timer, could possibly be faulty and cause the septic system to not work properly. There may be a problem with one of the septic system’s components.If too much standing water, caused by rain or another source, accumulates around the septic tanks, the water can potentially seep into the tanks and cause the internal water level to rise. Groundwater is somehow getting into the system.This is the result of too much water usage, which could be due to several loads of laundry, an abnormal amount of dishwashing, or maybe a lot of long showers. Too much water is being introduced into the septic system.Since the timer only allows the pump to come on for certain time intervals, it may take several pumping cycles before the water is pumped back down to normal levels, depending on how much water was and continues to be, introduced into the system. Consequently, the water level will rise inside the pump tank until the timer allows for the pump to come back on. If for whatever reason, a lot of water is being introduced into the system in between the pumping cycles, the water will have no place to go besides the pump tank. This prevents the drain field from becoming overflowed during any period of increased water use, which could potentially harm the drain field. These specific time intervals happen at key times during the day. The timer manages the time intervals within which the pump is allowed to pump wastewater into the drain field. All septic systems with pumps will normally have some sort of timer installed. The alarm works in coordination with the septic system for the purpose of warning you when the water level within the pump tank has risen too high or has dropped too low. If your issues persist, please reach out to us us at you’ve ever experienced your septic alarm going off, it can definitely cause some panic and confusion and if you happen to be experiencing that right now, you’ve come to the right place! Don’t worry, it does not necessarily require immediate attention, so take your time to read the entirety of this article so you know what to do either now or in the future. Check our blog for more information on how your modem works. If not, our tech support team is ready to help you. Hopefully after reading the information above, as well as our article on common router issues, you can successfully solve your connection problems and get your Internet back up and running. If you still cannot connect to the Internet, we recommend you contact our tech support team. Replace that cable, and then try your connection again.Ĭonnect your computer directly to your Tachus modemĪnother way to make sure your connection issues are not in your Tachus modem is to try connecting your computer directly into the modem’s GE1 port with an Ethernet cable. Is there an Ethernet cable going from the modem’s GE1 port to the router? Usually there is a specific port on a router for this cable labeled “Internet” or “WAN”. If not, the connection from the Tachus equipment works and there’s likely a problem with either your router or your connection from your Tachus modem to your router.Ĭheck your modem’s connection to your router Is there a red alarm light on the top of your Tachus modem? If there is, you’re having a problem with your connection and you should call us. The Tachus modem says DZS on it and should be located where our technician placed it during installation. If you’ve troubleshot and rebooted your wireless router, but you’re still not getting an Internet connection or you're experiencing slow speeds, here are some steps you can try with your Tachus modem.
0 Comments
Leave a Reply. |